WAEC Woodwork Questions and Answers 2022/2023 (Expo) Objective/Essay

WAEC Woodwork Questions and Answers Questions 2022/2023 Exams are here. Candidates who are ready to score very high in the Wood Work WAEC examination should make good use of this opportunity with likely WAEC woodwork expo.

WAEC Wood Work Questions and Answers

In this article we will provide all the necessary information needed to pass WAEC Woodwork very well. To make effective use of this page, follow the instructions given accordingly. WAEC Objectives and theory Questions and Answers for Woodwork.

WAEC Woodwork Objectives 2022 Questions and Answers

In the objectives part of the exams, candidates are required to take just an option. Don’t be confused, try reading the questions over and over again before choosing your option.

WAEC Woodwork  Answers

SEE: WAEC TimeTable

WAEC Wood work 2022 Essay Questions and Answers

The essay part is otherwise known as the theory part. in this Section, you are be expected to answers the questions you know best following the number of questions required by the instruction for each candidate to attempt. Make sure you make good use of this page.

(1) (a) Arrange the following mass production activities in their sequential order of occurrence:

(i) trial assembly;
(ii) procurement of materials;
(iii) preparation of working drawings;
(iv) final assembly;
(v) preparation of materials;
(vi) setting out and cutting of joints.
Wood Work Exam Date 1
Wood Work Exam Date 2:

b) List two types of widening joint.
(c) List two sources of funds open to a wood working sole proprietor.
Candidates were expected to do the following:
(1) arrange the listed activities in their sequential order of occurrence;
(2) list two widening joints;
(3) list two sources of funds open to a woodworking sole proprietor. The solution is shown below:

(a) Mass production activities in sequential order:
(i) preparation of working drawings;
(ii) procurement of materials;
(iii) preparation of materials;
(iv) setting out and cutting of joints;
(v) trial assembly;
(vi) final assembly.

(b) Types of widening joint:
(i) dowel joint;
(ii) tongued and grooved joint (tongue and groove joint);
(iii) loose tongue and groove joint (feather joint);
(iv) slot screw joint;
(v) rebated joint;
(vi) rubbed glued joint (plain butt joint);
(vii) biscuit joint.

(c) Sources of funds open to a woodworking sole proprietor:
(i) personal savings;
(ii) sale of shares;
(iii) loans from friends;
(iv) assistance from family members;
(v) loan from cooperatives;
(vi) thrift contributions (Esusu);
(vii) bank loans;
(viii) inheritance;
(ix) grants-in-aid from government/donor agencies;
(x) sale of personal property.

RECOMMENDED:

Try as much as possible to understand the questions before writing the answers. Your time management is also important. Do not waste much time on one question. The instructions on the question paper is for you, try your best to follow them

If there is anything else you need concerning the WAEC Wood work Questions and Answers, use the comments section below.

About admin

SYLVESTER AUGUSTUS, AKWA IBOM STATE, NIGERIA CONTACT: [email protected]

View all posts by admin →

Leave a Reply

Your email address will not be published.